Post edited 3:11 pm – May 11, 2010 by Dixie
Post edited 3:12 pm – May 11, 2010 by Dixie
Post edited 3:16 pm – May 11, 2010 by Dixie

Hello everyone,

I'm a newbie here, but have used Microstation for several years. Something really elementary has me baffled. I've been experimenting with 3D and all the sudden when I draw a sequence of lines that join, the area gets filled. Same with “place block”. Fill type is set to “none”. I can not figure out how to get rid of the fill. Where else can this setting be changed? This is driving me up the wall!

Any help would be greatly appreciated!!

Edit:

well, figured it out….Display style needs to be set on wireframe. Duh!